[RFC 00/24] OMAP serial driver flow control fixes, and preparation for DMA engine conversion

[Kevin Hilman]

Hi Sourav,

Sourav <sourav.poddar at ti.com> writes:

[...]

> Boot Tested this patch series against v3.6 tag(applied cleanly) on
> panda board and
> PM tested(hitting off in Idle and suspend) on omap3630 based beagle board.
>
> Note, I also tested the patches against the current master but only
> after rebasing, since the current master includes serial patches from
> Felipe Balbi[1].
> [1] https://lkml.org/lkml/2012/8/24/139
>
> Tested-by: Sourav Poddar <sourav.poddar at ti.com>

Did you test flow control after off-mode transitons?

Russell indicated that the context save/restore is not saving important
bits related to HW flow control, so I suspect some more testing,
specifically of flow control after off-mode is needed.

Kevin