[PATCH] ARM: dts: exynos4: Use drive strength 3 for SD pins

[Tomasz Figa]

Hi Kgene,

On Tuesday 20 of November 2012 20:10:25 Kukjin Kim wrote:
> Tomasz Figa wrote:
> > Hi Kgene,
> > 
> > On Tuesday 20 of November 2012 18:18:44 Kukjin Kim wrote:
> > > Tomasz Figa wrote:
> > > > This patch modifies pin control groups of SD pins on Exynos4210
> > > > and
> > > > Exynos4x12 to use drive strength 3, which corresponds to
> > > > S5P_GPIO_DRVSTR_LV4 in legacy non-DT code.
> > > 
> > > Well, the value of drive strength depends on board not SoC. So if
> > > required, it should be moved to board DT stuff.
> > 
> > Yes, I fully agree.
> > 
> > I've been thinking whether to change the defaults or just override
> > them
> > for Origen, but I came to a conclusion that 3 (LV4) was the default in
> > non-DT code, so it probably should be also the default in DT variant.
> 
> OK.
> 
> > > BTW, we can use the value as a default...I need to think about that
> > > again for exynos4210 and 4x12.
> > 
> > I wonder which default value is more appropriate, 0 or 3?
> 
> In this case, yes, '3' is more useful...so can you re-submit this patch
> with editing commit?

I can resubmit this patch, but I'm not sure what you expect me to edit. 
Could you explain?

If possible, it would be nice to get this included in 3.8 as it's required 
for Origen board to boot with device tree.

Best regards,
-- 
Tomasz Figa
Samsung Poland R&D Center
SW Solution Development, Linux Platform