[PATCH] ARM: dts: exynos4: Use drive strength 3 for SD pins

Kukjin Kim kgene.kim at samsung.com
Tue Nov 20 06:10:25 EST 2012


Tomasz Figa wrote:
> 
> Hi Kgene,
> 
> On Tuesday 20 of November 2012 18:18:44 Kukjin Kim wrote:
> > Tomasz Figa wrote:
> > > This patch modifies pin control groups of SD pins on Exynos4210 and
> > > Exynos4x12 to use drive strength 3, which corresponds to
> > > S5P_GPIO_DRVSTR_LV4 in legacy non-DT code.
> >
> > Well, the value of drive strength depends on board not SoC. So if
> > required, it should be moved to board DT stuff.
> 
> Yes, I fully agree.
> 
> I've been thinking whether to change the defaults or just override them
> for Origen, but I came to a conclusion that 3 (LV4) was the default in
> non-DT code, so it probably should be also the default in DT variant.
> 
OK.

> > BTW, we can use the value as a default...I need to think about that
> > again for exynos4210 and 4x12.
> 
> I wonder which default value is more appropriate, 0 or 3?
> 
In this case, yes, '3' is more useful...so can you re-submit this patch with
editing commit?

Thanks.

Best regards,
Kgene.
--
Kukjin Kim <kgene.kim at samsung.com>, Senior Engineer,
SW Solution Development Team, Samsung Electronics Co., Ltd.




More information about the linux-arm-kernel mailing list