[PATCH 3/3] ARM: dts: AM33XX: Add memory resource to d_can node

AnilKumar, Chimata anilkumar at ti.com
Tue Nov 20 05:23:57 EST 2012


On Tue, Nov 20, 2012 at 15:43:04, Marc Kleine-Budde wrote:
> On 11/14/2012 07:08 PM, AnilKumar Ch wrote:
> > Add a new address space/memory resource to d_can device tree node. D_CAN
> > RAM initialization is achieved through RAMINIT register which is part of
> > AM33XX control module address space. D_CAN RAM init or de-init should be
> > done by writing instance corresponding value to control module register.
> > 
> > Till we have a separate control module driver to write to control module,
> > d_can driver will handle the register writes to control module by itself.
> > So a new address space to represent this control module register is added
> > to d_can driver.
> > 
> > Signed-off-by: AnilKumar Ch <anilkumar at ti.com>
> 
> This does not apply to net-next/master:
> 
> Applying: ARM: dts: AM33XX: Add memory resource to d_can node
> error: patch failed: arch/arm/boot/dts/am33xx.dtsi:227
> error: arch/arm/boot/dts/am33xx.dtsi: patch does not apply
> Patch failed at 0003 ARM: dts: AM33XX: Add memory resource to d_can node
> 

Marc,

Sorry about this DT changes are present in linux-omap.

Could you please take the driver changes only and ACK on remaining will
help.

Tony/Benoit,

Could you please take dt patches in this series to linux-omap?

Thanks
AnilKumar



More information about the linux-arm-kernel mailing list