[PATCH] video: EXYNOS: enable interrupt again after sw reset

[Florian Tobias Schandinat]

On 05/04/2012 04:59 AM, Donghwa Lee wrote:
> When exynos_mipi_update_cfg() is called, mipi dsi registers were become
> sw reset. So, It needs to enable interrupt again.
> 
> Signed-off-by: Donghwa Lee <dh09.lee at samsung.com>
> Signed-off-by: Inki Dae <inki.dae at samsung.com>
> Signed-off-by: Kyungmin Park <kyungmin.park at samsung.com>

Applied.


Thanks,

Florian Tobias Schandinat

> ---
>  drivers/video/exynos/exynos_mipi_dsi.c |    2 ++
>  1 files changed, 2 insertions(+), 0 deletions(-)
> 
> diff --git a/drivers/video/exynos/exynos_mipi_dsi.c b/drivers/video/exynos/exynos_mipi_dsi.c
> index 557091d..49c7351 100644
> --- a/drivers/video/exynos/exynos_mipi_dsi.c
> +++ b/drivers/video/exynos/exynos_mipi_dsi.c
> @@ -102,6 +102,8 @@ static void exynos_mipi_update_cfg(struct mipi_dsim_device *dsim)
>  	/* set display timing. */
>  	exynos_mipi_dsi_set_display_mode(dsim, dsim->dsim_config);
>  
> +	exynos_mipi_dsi_init_interrupt(dsim);
> +
>  	/*
>  	 * data from Display controller(FIMD) is transferred in video mode
>  	 * but in case of command mode, all settigs is updated to registers.