[PATCH] video: EXYNOS: enable interrupt again after sw reset

[Donghwa Lee]

When exynos_mipi_update_cfg() is called, mipi dsi registers were become
sw reset. So, It needs to enable interrupt again.

Signed-off-by: Donghwa Lee <dh09.lee at samsung.com>
Signed-off-by: Inki Dae <inki.dae at samsung.com>
Signed-off-by: Kyungmin Park <kyungmin.park at samsung.com>
---
 drivers/video/exynos/exynos_mipi_dsi.c |    2 ++
 1 files changed, 2 insertions(+), 0 deletions(-)

diff --git a/drivers/video/exynos/exynos_mipi_dsi.c b/drivers/video/exynos/exynos_mipi_dsi.c
index 557091d..49c7351 100644
--- a/drivers/video/exynos/exynos_mipi_dsi.c
+++ b/drivers/video/exynos/exynos_mipi_dsi.c
@@ -102,6 +102,8 @@ static void exynos_mipi_update_cfg(struct mipi_dsim_device *dsim)
 	/* set display timing. */
 	exynos_mipi_dsi_set_display_mode(dsim, dsim->dsim_config);
 
+	exynos_mipi_dsi_init_interrupt(dsim);
+
 	/*
 	 * data from Display controller(FIMD) is transferred in video mode
 	 * but in case of command mode, all settigs is updated to registers.
-- 
1.7.4.1