[PATCH V7 1/5] AHCI Add the AHCI SATA feature on the MX53 platforms

[Eric Miao]

On Thu, Sep 22, 2011 at 5:30 PM, Hector Oron <hector.oron at gmail.com> wrote:
> Hello,
>
>  Apologies for late reply.
>
> 2011/9/6 Eric Miao <eric.miao at linaro.org>:
>> On Tue, Sep 6, 2011 at 1:46 AM, Hector Oron <hector.oron at gmail.com> wrote:
>>> 2011/9/1 Richard Zhu <richard.zhu at linaro.org>:
>
>>> Here is my complete dmesg. The system seems to work fine, it is a
>>> 1.0TB WD10TPVT SATA disk in a case which provides eSATA and connected
>>> to mx53 LOCO with eSATA-to-SATA cable.
>
>> Is it possible that it's caused by this converter? Do you have a separate
>> SATA power supply that could help test the disk directly connected to
>> mx53loco?
>
> I think I had a bad configuration setup for my kernel. I have rebuilt
> 3.1.0-rc6 from Sascha's master git with this patches and now SATA is
> working properly I do not see any issue as I did. So, from my side all
> is OK now, and I assume I had some missing or conflicting module
> setup.
>
> Kind regards and apologies for inconveniences,

That's great, Herton. Can we take it as a Tested-by?

> --
>  Héctor Orón  -.. . -... .. .- -.   -.. . ...- . .-.. --- .--. . .-.
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
>