[PATCH V7 1/5] AHCI Add the AHCI SATA feature on the MX53 platforms

[Hector Oron]

Hello,

  Apologies for late reply.

2011/9/6 Eric Miao <eric.miao at linaro.org>:
> On Tue, Sep 6, 2011 at 1:46 AM, Hector Oron <hector.oron at gmail.com> wrote:
>> 2011/9/1 Richard Zhu <richard.zhu at linaro.org>:

>> Here is my complete dmesg. The system seems to work fine, it is a
>> 1.0TB WD10TPVT SATA disk in a case which provides eSATA and connected
>> to mx53 LOCO with eSATA-to-SATA cable.

> Is it possible that it's caused by this converter? Do you have a separate
> SATA power supply that could help test the disk directly connected to
> mx53loco?

I think I had a bad configuration setup for my kernel. I have rebuilt
3.1.0-rc6 from Sascha's master git with this patches and now SATA is
working properly I do not see any issue as I did. So, from my side all
is OK now, and I assume I had some missing or conflicting module
setup.

Kind regards and apologies for inconveniences,
-- 
 Héctor Orón  -.. . -... .. .- -.   -.. . ...- . .-.. --- .--. . .-.