[PATCH 21/25] OMAP4: PM: Add MPUSS power domain OSWR support

Santosh santosh.shilimkar at ti.com
Tue Sep 13 01:37:57 EDT 2011


On Tuesday 13 September 2011 12:22 AM, Kevin Hilman wrote:
> Santosh Shilimkar<santosh.shilimkar at ti.com>  writes:
>
>> This patch adds the MPUSS OSWR (Open Switch Retention) support. The MPUSS
>> OSWR configuration is as below.
>> 	- CPUx L1 and logic lost, MPUSS logic lost, L2 memory is retained
>>
>> OMAP4460 onwards, MPUSS power domain doesn't support OFF state any more
>> anymore just like CORE power domain. The deepest state supported is OSWR.
>> On OMAP4430 secure devices too, MPUSS off mode can't be used because of
>> a bug which alters Ducati and Tesla states. Hence MPUSS off mode as an
>> independent state isn't supported on OMAP44XX devices.
>>
>> Ofcourse when MPUSS power domain transitions to OSWR along
>> with device off mode, it eventually hits off state since memory
>> contents are lost.
>>
>> Hence the MPUSS off mode independent state is not attempted without
>> device off mode. All the necessary infrastructure code for MPUSS
>> off mode is in place as part of this series.
>>
>> Signed-off-by: Santosh Shilimkar<santosh.shilimkar at ti.com>
>> Cc: Kevin Hilman<khilman at ti.com>
>
> Compile failure for the !CONFIG_PM case:
>
> [...]
>
>> @@ -70,11 +71,18 @@ static inline int omap4_mpuss_init(void)
>>   {
>>   	return 0;
>>   }
>> -
>> +static inline u32 omap4_mpuss_read_prev_context_state(void)
>> +{
>> +	return 0;
>> +}
>
> added here
>
>>   static inline int omap4_finish_suspend(unsigned long cpu_state)
>>   {}
>>   static inline void omap4_cpu_resume(void)
>>   {}
>> +static inline u32 omap4_mpuss_read_prev_context_state(void)
>> +{
>> +	return 0;
>> +}
>
> same thing added here
>
I noticed this yesterday and was planning to send a note on this
patch. :(
Have removed this already in the updated patches.
Thanks for pointing it out.

Regards
Santosh




More information about the linux-arm-kernel mailing list