[PATCH 06/11] ARM: at91/mmc: use gpio_is_valid to check the gpio
Jean-Christophe PLAGNIOL-VILLARD
plagnioj at jcrosoft.com
Sun Oct 16 15:09:15 EDT 2011
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre at atmel.com>
---
drivers/mmc/host/at91_mci.c | 30 +++++++++++++++---------------
1 files changed, 15 insertions(+), 15 deletions(-)
diff --git a/drivers/mmc/host/at91_mci.c b/drivers/mmc/host/at91_mci.c
index a4aa3af..7504b22 100644
--- a/drivers/mmc/host/at91_mci.c
+++ b/drivers/mmc/host/at91_mci.c
@@ -741,7 +741,7 @@ static void at91_mci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
at91_mci_write(host, AT91_MCI_MR, (at91_mci_read(host, AT91_MCI_MR) & ~AT91_MCI_CLKDIV) | clkdiv);
/* maybe switch power to the card */
- if (host->board->vcc_pin) {
+ if (gpio_is_valid(host->board->vcc_pin)) {
switch (ios->power_mode) {
case MMC_POWER_OFF:
gpio_set_value(host->board->vcc_pin, 0);
@@ -893,7 +893,7 @@ static int at91_mci_get_ro(struct mmc_host *mmc)
{
struct at91mci_host *host = mmc_priv(mmc);
- if (host->board->wp_pin)
+ if (gpio_is_valid(host->board->wp_pin))
return !!gpio_get_value(host->board->wp_pin);
/*
* Board doesn't support read only detection; let the mmc core
@@ -987,21 +987,21 @@ static int __init at91_mci_probe(struct platform_device *pdev)
* Reserve GPIOs ... board init code makes sure these pins are set
* up as GPIOs with the right direction (input, except for vcc)
*/
- if (host->board->det_pin) {
+ if (gpio_is_valid(host->board->det_pin)) {
ret = gpio_request(host->board->det_pin, "mmc_detect");
if (ret < 0) {
dev_dbg(&pdev->dev, "couldn't claim card detect pin\n");
goto fail4b;
}
}
- if (host->board->wp_pin) {
+ if (gpio_is_valid(host->board->wp_pin)) {
ret = gpio_request(host->board->wp_pin, "mmc_wp");
if (ret < 0) {
dev_dbg(&pdev->dev, "couldn't claim wp sense pin\n");
goto fail4;
}
}
- if (host->board->vcc_pin) {
+ if (gpio_is_valid(host->board->vcc_pin)) {
ret = gpio_request(host->board->vcc_pin, "mmc_vcc");
if (ret < 0) {
dev_dbg(&pdev->dev, "couldn't claim vcc switch pin\n");
@@ -1053,7 +1053,7 @@ static int __init at91_mci_probe(struct platform_device *pdev)
/*
* Add host to MMC layer
*/
- if (host->board->det_pin) {
+ if (gpio_is_valid(host->board->det_pin)) {
host->present = !gpio_get_value(host->board->det_pin);
}
else
@@ -1064,7 +1064,7 @@ static int __init at91_mci_probe(struct platform_device *pdev)
/*
* monitor card insertion/removal if we can
*/
- if (host->board->det_pin) {
+ if (gpio_is_valid(host->board->det_pin)) {
ret = request_irq(gpio_to_irq(host->board->det_pin),
at91_mmc_det_irq, 0, mmc_hostname(mmc), host);
if (ret)
@@ -1083,13 +1083,13 @@ fail0:
fail1:
clk_put(host->mci_clk);
fail2:
- if (host->board->vcc_pin)
+ if (gpio_is_valid(host->board->vcc_pin))
gpio_free(host->board->vcc_pin);
fail3:
- if (host->board->wp_pin)
+ if (gpio_is_valid(host->board->wp_pin))
gpio_free(host->board->wp_pin);
fail4:
- if (host->board->det_pin)
+ if (gpio_is_valid(host->board->det_pin))
gpio_free(host->board->det_pin);
fail4b:
if (host->buffer)
@@ -1121,7 +1121,7 @@ static int __exit at91_mci_remove(struct platform_device *pdev)
dma_free_coherent(&pdev->dev, MCI_BUFSIZE,
host->buffer, host->physical_address);
- if (host->board->det_pin) {
+ if (gpio_is_valid(host->board->det_pin)) {
if (device_can_wakeup(&pdev->dev))
free_irq(gpio_to_irq(host->board->det_pin), host);
device_init_wakeup(&pdev->dev, 0);
@@ -1136,9 +1136,9 @@ static int __exit at91_mci_remove(struct platform_device *pdev)
clk_disable(host->mci_clk); /* Disable the peripheral clock */
clk_put(host->mci_clk);
- if (host->board->vcc_pin)
+ if (gpio_is_valid(host->board->vcc_pin))
gpio_free(host->board->vcc_pin);
- if (host->board->wp_pin)
+ if (gpio_is_valid(host->board->wp_pin))
gpio_free(host->board->wp_pin);
iounmap(host->baseaddr);
@@ -1159,7 +1159,7 @@ static int at91_mci_suspend(struct platform_device *pdev, pm_message_t state)
struct at91mci_host *host = mmc_priv(mmc);
int ret = 0;
- if (host->board->det_pin && device_may_wakeup(&pdev->dev))
+ if (gpio_is_valid(host->board->det_pin) && device_may_wakeup(&pdev->dev))
enable_irq_wake(host->board->det_pin);
if (mmc)
@@ -1174,7 +1174,7 @@ static int at91_mci_resume(struct platform_device *pdev)
struct at91mci_host *host = mmc_priv(mmc);
int ret = 0;
- if (host->board->det_pin && device_may_wakeup(&pdev->dev))
+ if (gpio_is_valid(host->board->det_pin) && device_may_wakeup(&pdev->dev))
disable_irq_wake(host->board->det_pin);
if (mmc)
--
1.7.7
More information about the linux-arm-kernel
mailing list