[PATCH] arm/tegra: select AUTO_ZRELADDR by default

[Russell King - ARM Linux]

On Fri, Oct 14, 2011 at 04:14:12PM -0400, Nicolas Pitre wrote:
> On Fri, 14 Oct 2011, Russell King - ARM Linux wrote:
> 
> > On Fri, Oct 14, 2011 at 02:01:07PM -0400, Nicolas Pitre wrote:
> > > The way I'm restructuring things around this is that AUTO_ZRELADDR will 
> > > always be active by default, just like ARM_PATCH_PHYS_VIRT now.  This 
> > > platform specific exclusion thinking is a step backward so I'd prefer if 
> > > people would refrain from going there for the moment.
> > 
> > Are you expecting everyone to change the way they load the zImage
> > overnight then?
> 
> No, of course.  But adding restrictions in the kernel build because 
> u-Boot's own image format dictates such restrictions doesn't make sense.  
> Those restrictions must be pushed towards the uImage encapsulation step, 
> not higher the kernel config hierarchy.

You're not understanding again.

I'm talking about people who _explicitly_ load the zImage at a different
address to which the decompressed image ends up.  With AUTO_ZRELADDR=y
their setup will break unless they stop that behaviour, which takes
away one of the advantages of using the zImage format.