[PATCH v2 2/5] tty/serial: atmel_serial: change platform_data variable name
Grant Likely
grant.likely at secretlab.ca
Wed Oct 12 21:01:34 EDT 2011
On Wed, Oct 12, 2011 at 06:06:57PM +0200, Nicolas Ferre wrote:
> Easier to follow if platform_data name is pdata.
>
> Signed-off-by: Nicolas Ferre <nicolas.ferre at atmel.com>
Acked-by: Grant Likely <grant.likely at secretlab.ca>
> ---
> drivers/tty/serial/atmel_serial.c | 14 +++++++-------
> 1 files changed, 7 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
> index c7232a9..a507daa 100644
> --- a/drivers/tty/serial/atmel_serial.c
> +++ b/drivers/tty/serial/atmel_serial.c
> @@ -1417,13 +1417,13 @@ static void __devinit atmel_init_port(struct atmel_uart_port *atmel_port,
> struct platform_device *pdev)
> {
> struct uart_port *port = &atmel_port->uart;
> - struct atmel_uart_data *data = pdev->dev.platform_data;
> + struct atmel_uart_data *pdata = pdev->dev.platform_data;
>
> port->iotype = UPIO_MEM;
> port->flags = UPF_BOOT_AUTOCONF;
> port->ops = &atmel_pops;
> port->fifosize = 1;
> - port->line = data->num;
> + port->line = pdata->num;
> port->dev = &pdev->dev;
> port->mapbase = pdev->resource[0].start;
> port->irq = pdev->resource[1].start;
> @@ -1433,9 +1433,9 @@ static void __devinit atmel_init_port(struct atmel_uart_port *atmel_port,
>
> memset(&atmel_port->rx_ring, 0, sizeof(atmel_port->rx_ring));
>
> - if (data->regs)
> + if (pdata->regs)
> /* Already mapped by setup code */
> - port->membase = data->regs;
> + port->membase = pdata->regs;
> else {
> port->flags |= UPF_IOREMAP;
> port->membase = NULL;
> @@ -1450,9 +1450,9 @@ static void __devinit atmel_init_port(struct atmel_uart_port *atmel_port,
> /* only enable clock when USART is in use */
> }
>
> - atmel_port->use_dma_rx = data->use_dma_rx;
> - atmel_port->use_dma_tx = data->use_dma_tx;
> - atmel_port->rs485 = data->rs485;
> + atmel_port->use_dma_rx = pdata->use_dma_rx;
> + atmel_port->use_dma_tx = pdata->use_dma_tx;
> + atmel_port->rs485 = pdata->rs485;
> /* Use TXEMPTY for interrupt when rs485 else TXRDY or ENDTX|TXBUFE */
> if (atmel_port->rs485.flags & SER_RS485_ENABLED)
> atmel_port->tx_done_mask = ATMEL_US_TXEMPTY;
> --
> 1.7.5.4
>
More information about the linux-arm-kernel
mailing list