[PATCH v6 09/16] OMAP2+: UART: Add runtime pm support for omap-serial driver

[Kevin Hilman]

"Govindraj.R" <govindraj.raja at ti.com> writes:

> Adapts omap-serial driver to use pm_runtime API's.
>
> Use runtime runtime API's to handle uart clocks and obtain
> device_usage statics. Set runtime API's usage to irq_safe so that
> we can use get_sync from irq context. Auto-suspend for port specific
> activities and put for reg access. Use device_may_wakeup to check
> whether uart has wakeup capabilities and then enable uart runtime
> usage for the uart.

OK.  Current patch should do only this part.  The rest should be
separate patches with their own descriptive changelogs.

> Removing save_context/restore_context functions from serial.c
> Adding context restore to .runtime_suspend and using reg values from port
> structure to restore the uart port context based on context_loss_count.
> Maintain internal state machine using wakeups_enabled field for avoiding
> repeated enable/disable of uart port wakeup mechanism.

This part should be a separate patch that follows.

> Remove omap_uart_disable_wakeup and modify omap_uart_enable_wakeup
> to accept pdev and bool value to enable/disable the uart wakeup mechanism
> after uart clock's are cut. 
>
> omap_hwmod_enable_wakeup is used to set
> pad wakeup for the uarts. PM_WKEN reg values are left to default.
> Removed omap_uart_enable/disable_clocks in serial.c now clock handling
> done with runtime API's.

As stated in previous reviews, this wakeup enable/disable needs more
description as the functionality is changing compared to current code.

Current version modifies wakeup enable/disable at both power-domain
level (PM_WKEN) and at the IO ring. 

Updated version modifies wakeups at module-level (SYSCONFIG) and at IO
ring using omap_hwmod_enable_wakeup()

IMO, the updated version makes more sense, but needs a description as to
why that change in functionality will have equivalent results compared
to the existing one.

> By default uart autosuspend delay is set to -1 to avoid character loss
> if uart's are autoidled and woken up on rx pin.

OK, good.

> After boot up UART's can be autoidled by setting autosuspendi delay from sysfs.
>
> echo 3000 > /sys/devices/platform/omap/omap_uart.X/power/autosuspend_delay_ms
> X=0,1,2,3 for UART1/2/3/4. Number of uarts available may vary across omap_soc.
>
> Acked-by: Alan Cox <alan at linux.intel.com>
> Signed-off-by: Govindraj.R <govindraj.raja at ti.com>

Kevin