[GIT PULL] Samsung devel-2 for v3.2

[Kukjin Kim]

Mark Brown wrote:
> 
> On Thu, Oct 06, 2011 at 04:57:01PM +0100, Mark Brown wrote:
> 
> > The bisect did end up pointing at the GPIO commits, the build errors
> > were causing issues.  Not really made any further progress on this issue
> > today, some other things came up.
> 
> So, I've been trying some other directions here.  What I'm seeing by
> pulling devices out of my config is that if I enable the LCD power
> control then the board fails to boot.  Also, the I2C controllers appear
> to be non-functional - I'm getting timeouts waiting for the bus to
> become free which halt the boot for long enough that it'd look like it
> had crashed if all the devices came up (there's a lot of I2C devices
> there).
> 
> I've not had time to actually drill down below that level but it did
> occur to me that there may be a problem with the pinmux code?

Mark, OK.

I will check and fix in this weekend before upcoming merge window ;)
Then it will be sent to upstream via arm-soc.

Thanks.

Best regards,
Kgene.
--
Kukjin Kim <kgene.kim at samsung.com>, Senior Engineer,
SW Solution Development Team, Samsung Electronics Co., Ltd.