[PATCH 10/26] ARM: pxa: allow selecting just one of TREO680/CENTRO

[Arnd Bergmann]

There are two variants of the palmtreo machine, the 680 and the
centro, and Kconfig allows selecting one or both of them.
This changes the board file so that it's actually possible
to build all configurations that are allowed.

Signed-off-by: Arnd Bergmann <arnd at arndb.de>
---
 arch/arm/mach-pxa/palmtreo.c |    8 ++++++++
 1 files changed, 8 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-pxa/palmtreo.c b/arch/arm/mach-pxa/palmtreo.c
index bb27d4b..30364b0 100644
--- a/arch/arm/mach-pxa/palmtreo.c
+++ b/arch/arm/mach-pxa/palmtreo.c
@@ -423,6 +423,7 @@ static void __init palmphone_common_init(void)
 	palmtreo_leds_init();
 }
 
+#ifdef CONFIG_MACH_TREO680
 static void __init treo680_init(void)
 {
 	pxa2xx_mfp_config(ARRAY_AND_SIZE(treo680_pin_config));
@@ -430,7 +431,9 @@ static void __init treo680_init(void)
 	palm27x_mmc_init(GPIO_NR_TREO_SD_DETECT_N, GPIO_NR_TREO680_SD_READONLY,
 			GPIO_NR_TREO680_SD_POWER, 0);
 }
+#endif
 
+#ifdef CONFIG_MACH_CENTRO
 static void __init centro_init(void)
 {
 	pxa2xx_mfp_config(ARRAY_AND_SIZE(centro685_pin_config));
@@ -438,7 +441,9 @@ static void __init centro_init(void)
 	palm27x_mmc_init(GPIO_NR_TREO_SD_DETECT_N, -1,
 			GPIO_NR_CENTRO_SD_POWER, 1);
 }
+#endif
 
+#ifdef CONFIG_MACH_TREO680
 MACHINE_START(TREO680, "Palm Treo 680")
 	.boot_params    = 0xa0000100,
 	.map_io         = pxa27x_map_io,
@@ -448,7 +453,9 @@ MACHINE_START(TREO680, "Palm Treo 680")
 	.timer          = &pxa_timer,
 	.init_machine   = treo680_init,
 MACHINE_END
+#endif
 
+#ifdef CONFIG_MACH_CENTRO
 MACHINE_START(CENTRO, "Palm Centro 685")
 	.boot_params    = 0xa0000100,
 	.map_io         = pxa27x_map_io,
@@ -458,3 +465,4 @@ MACHINE_START(CENTRO, "Palm Centro 685")
 	.timer          = &pxa_timer,
 	.init_machine	= centro_init,
 MACHINE_END
+#endif
-- 
1.7.5.4