2.6.38 port not booting on i.MX53 SoM

[Wolfgang Grandegger]

On 11/29/2011 12:20 PM, Wayne Tams wrote:
> On Tue, Nov 29, 2011 at 11:12 AM, Fabio Estevam <festevam at gmail.com> wrote:
>> 2011/11/29 Wayne Tams <wayne.tams at gmail.com>:
>>
>>> I have followed your instructions and double checked serial bootargs
>>> by loading the 2.6.35 kernel; 2.6.35 loads ok displaying printks as it
>>> executes.
>>>
>>> However using the new 2.6.38 kernel, there are not any additional
>>> messages after enabling the debug settings you mentioned.
>>
>> As Uwe explained this list is about mainline kernel.
>>
>> I have a suggestion for you though: if you use FSL 2.6.38 you should
>> update your FSL U-boot also because there were some UART clock changes
>> from 2.6.35 to 2.6.38. Or use the mainline kernel instead ;-)
>>
>> Regards,
>>
>> Fabio Estevam
> 
> Understood, thanks for the help all the same. :)

Try the following patch:

http://git.linaro.org/gitweb?p=bsp/freescale/linux-linaro-natty.git;a=commit;h=c00c6cd2b83e88292f82387dacf489b2821d2ce2

Wolfgang.