[PATCH 02/15] OMAP: GPIO: remove MPUIO handling from _clear_gpio_irqbank()

Kevin Hilman khilman at ti.com
Tue May 3 12:27:36 EDT 2011


"Varadarajan, Charulatha" <charu at ti.com> writes:

> Kevin,
>
> On Sat, Apr 23, 2011 at 04:31, Kevin Hilman <khilman at ti.com> wrote:
>> Remove the OMAP1 #ifdef and MPUIO special case for _clear_gpio_irqbank()
>>
>> The MPUIOs do not need a register access to ack/clear the IRQ status,
>> since reading the IRQ status clears it.  In addition, the MPUIO
>> irq_chip has an empty ack method, so _clear_gpio_irqbank() is never
>> used for MPUIOs.
>>
>> Signed-off-by: Kevin Hilman <khilman at ti.com>
>> ---
>>  arch/arm/plat-omap/gpio.c |    6 ------
>>  1 files changed, 0 insertions(+), 6 deletions(-)
>>
>> diff --git a/arch/arm/plat-omap/gpio.c b/arch/arm/plat-omap/gpio.c
>> index fe6971a..8b5ca6e 100644
>> --- a/arch/arm/plat-omap/gpio.c
>> +++ b/arch/arm/plat-omap/gpio.c
>> @@ -770,12 +770,6 @@ static void _clear_gpio_irqbank(struct gpio_bank *bank, int gpio_mask)
>>        void __iomem *reg = bank->base;
>>
>>        switch (bank->method) {
>> -#ifdef CONFIG_ARCH_OMAP1
>> -       case METHOD_MPUIO:
>> -               /* MPUIO irqstatus is reset by reading the status register,
>> -                * so do nothing here */
>> -               return;
>> -#endif
>
> The default case has a "WARN_ON(1)". I guess WARN_ON()
> is not required for METHOD_MPUIO.

As stated in the changelog, this function is never called for MPUIO
banks, so the warning should not be hit.

Kevin





More information about the linux-arm-kernel mailing list