[RFC] ARM: Cortex-A9: Enable dynamic clock gating
Santosh Shilimkar
santosh.shilimkar at ti.com
Fri Mar 11 12:23:29 EST 2011
> -----Original Message-----
> From: linux-arm-kernel-bounces at lists.infradead.org [mailto:linux-
> arm-kernel-bounces at lists.infradead.org] On Behalf Of Catalin Marinas
> Sent: Friday, March 11, 2011 10:38 PM
> To: Todd Poynor
> Cc: linux-arm-kernel at lists.infradead.org
> Subject: Re: [RFC] ARM: Cortex-A9: Enable dynamic clock gating
>
> On Wed, 2011-02-23 at 03:55 +0000, Todd Poynor wrote:
> > Enable dynamic high level clock gating for Cortex-A9 CPUs, as
> > described in 2.3.3 "Dynamic high level clock gating" of the
> > Cortex-A9 TRM. This may cut the clock of the integer core,
> > system control block, and Data Engine in certain conditions.
> >
> > Add ARM errata 720791 to avoid corrupting the Jazelle
> > instruction stream on earlier Cortex-A9 revisions.
> >
> > Signed-off-by: Todd Poynor <toddpoynor at google.com>
> > ---
> > Can anyone advise whether this feature should be selectively
> > enabled (or otherwise modified) due to secured register access,
> > introduced latencies observed, etc.?
> >
> > This has been tested on a few Tegra 2 boards without problems
> > observed thus far, and some preliminary testing indicates it
> > may result in fairly significant power savings. Any additional
> > testing greatly appreciated.
>
> I haven't done any benchmarks on this, so can't comment on this.
>
> My view is that something like the boot monitor/firmware should set
> this
> up, though that's not always the case. On some OMAP boards Linux
> runs in
> non-secure mode and it will fault when trying to set this bit.
>
Or this can be also enabled in the SOC PM initiliasation code
instead of generic code so that the kernel is independent of
boot loaders. Ofcourse downside to this is, every SOC will have
this code duplicated.
Regards,
Santosh
More information about the linux-arm-kernel
mailing list