[PATCH V3 03/19] OMAP3+: voltage: remove initial voltage

Sergei Shtylyov sshtylyov at mvista.com
Sun Mar 6 08:37:08 EST 2011


Hello.

On 05-03-2011 18:29, Nishanth Menon wrote:

> Blindly setting a 1.2V setting

    Hm, seems tautological...

> in the initial structure may not even
> match the default voltages stored in the voltage table which are
> supported for the domain. For example, OMAP3430 core domain does not
> use 1.2V and ends up generating a warning on the first transition.

> Further, since omap2_set_init_voltage is called as part of the pm
> framework's initialization sequence to configure the voltage required
> for the current OPP, the call does(and has to) setup the system
> voltage(curr_volt as a result) using the right mechanisms appropriate
> for the system at that point of time. This also overrides
> initialization we are currently doing in voltage.c making it
> redundant. So, remove the wrong and redundant initialization.

> Signed-off-by: Nishanth Menon<nm at ti.com>

WBR, Sergei



More information about the linux-arm-kernel mailing list