[PATCH 2/7] OMAP2+: mux: Enable wakeup for wakeup enable requested pads

[Kevin Hilman]

Kevin Hilman <khilman at ti.com> writes:

> "Govindraj.R" <govindraj.raja at ti.com> writes:

[...]

>>  /* Assumes the calling function takes care of locking */
>>  void omap_hwmod_mux(struct omap_hwmod_mux_info *hmux, u8 state)
>>  {
>> @@ -342,6 +365,9 @@ void omap_hwmod_mux(struct omap_hwmod_mux_info *hmux, u8 state)
>>  				break;
>>  			flags &= ~OMAP_DEVICE_PAD_ENABLED;
>>  			val = pad->idle;
>> +			if (flags & OMAP_DEVICE_PAD_WAKEUP)
>> +				val |= OMAP_WAKEUP_EN;
>> +
>
> Is this needed on every idle transition?  
>
> You're currently setting it on every idle transition, but never clearing
> it.  If it is to be a one-time thing, then move it to the early init of
> the mux.

Just to clarify...

So as soon as the hwmod is first idled, IO-ring wakeups are enabled for
any pads that have OMAP_DEVICE_PAD_WAKEUP.

The problem here (compared with behavior of existing code) is that there 
is no provision for disabling IO-ring wakeups.

For example, with current code, you can disable wakeups from userspace
using the sysfs control file /sys/devices/.../power/wakeup, whose value
can be checked using device_may_wakeup(), like current
mach-omap2/serial.c code does.  

With this patch, IO-ring wakeups are always enabled, and never disabled.

Kevin