[PATCH] at91: fix at91rm9200 soc subtype handling
Veli-Pekka Peltola
veli-pekka.peltola at bluegiga.com
Wed Dec 28 06:10:04 EST 2011
BGA should be the default SoC subtype but it is set to unknown if
not explicitly set to PQFP. Currently setting it to PQFP sets subtype
to BGA as subtypes are swapped in at91rm9200_set_type().
Wrong subtype causes GPIO bank D not to work at all.
After this fix BGA subtype is set as default. On boot BGA is printed
always but it is set to PQFP if requested before setting amount of GPIO
banks.
Signed-off-by: Veli-Pekka Peltola <veli-pekka.peltola at bluegiga.com>
---
arch/arm/mach-at91/setup.c | 5 +++--
1 files changed, 3 insertions(+), 2 deletions(-)
diff --git a/arch/arm/mach-at91/setup.c b/arch/arm/mach-at91/setup.c
index aa64294..e6b07ad 100644
--- a/arch/arm/mach-at91/setup.c
+++ b/arch/arm/mach-at91/setup.c
@@ -27,9 +27,9 @@ EXPORT_SYMBOL(at91_soc_initdata);
void __init at91rm9200_set_type(int type)
{
if (type == ARCH_REVISON_9200_PQFP)
- at91_soc_initdata.subtype = AT91_SOC_RM9200_BGA;
- else
at91_soc_initdata.subtype = AT91_SOC_RM9200_PQFP;
+ else
+ at91_soc_initdata.subtype = AT91_SOC_RM9200_BGA;
}
void __init at91_init_irq_default(void)
@@ -118,6 +118,7 @@ static void __init soc_detect(u32 dbgu_base)
case ARCH_ID_AT91RM9200:
at91_soc_initdata.type = AT91_SOC_RM9200;
+ at91_soc_initdata.subtype = AT91_SOC_RM9200_BGA;
at91_boot_soc = at91rm9200_soc;
break;
--
1.7.5.4
More information about the linux-arm-kernel
mailing list