[PATCH v2] AT91: Add flexibity board support

[Jean-Christophe PLAGNIOL-VILLARD]

On 09:57 Tue 14 Sep     , Maxim Osipov wrote:
> Please see my comments below...
> 
> On Tue, Sep 14, 2010 at 12:53 AM, Ryan Mallon <ryan at bluewatersys.com> wrote:
> > On 09/13/2010 10:18 PM, Maxim Osipov wrote:
> >
> >> +static void __init flexibity_board_init(void)
> >> +{
> >> +     /* Serial */
> >> +     at91_add_device_serial();
> >> +     /* USB Host */
> >> +     at91_add_device_usbh(&flexibity_usbh_data);
> >> +     /* USB Device */
> >> +     at91_add_device_udc(&flexibity_udc_data);
> >> +     /* SPI */
> >> +     at91_add_device_spi(flexibity_spi_devices,
> >> +             ARRAY_SIZE(flexibity_spi_devices));
> >> +     /* MMC */
> >> +     at91_add_device_mmc(0, &flexibity_mmc_data);
> >> +     /* LEDs */
> >> +     at91_gpio_leds(flexibity_leds, ARRAY_SIZE(flexibity_leds));
> >
> > Can we drop all the comments inside this function please. They don't add
> > any information and they make it harder to read the actual code.
> >
> 
> Ryan, thank you for the review. However I would like to keep these
> comments - for some devices, like UDC - it really provides
> clarification. Reading the code is not a problem with proper
> highlighting scheme.
agreed no need to change

Best Regards,
J.