[PATCH 43/74] ST SPEAr : EMI (Extrenal Memory Interface) controller driver

[Vipin Kumar]

On 9/10/2010 2:26 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 13:41 Fri 10 Sep     , Vipin Kumar wrote:
>> On 9/7/2010 7:02 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
>>> On 17:24 Tue 07 Sep     , viresh kumar wrote:
>>>> On 9/7/2010 5:08 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
>>>>>>>> +/* emi nor flash device registeration */
>>>>>>>>>>>>> +static struct physmap_flash_data emi_norflash_data;
>>>>>>>>>>>>> +
>>>>>>>>>>>>> +static struct resource emi_nor_resources[] = {
>>>>>>>>>>>>> +     {
>>>>>>>>>>>>> +             .start  = SPEAR310_EMI_MEM_0_BASE,
>>>>>>>>>>>>> +             .end    = SPEAR310_EMI_MEM_0_BASE + SPEAR310_EMI_MEM_SIZE - 1,
>>>>>>>>>>>>> +             .flags  = IORESOURCE_MEM,
>>>>>>>>>>>>> +     },
>>>>>>>>>>>>> +};
>>>>>>>>> it's board specfic not mach
>>>>>>>>>
>>>>>>>>> NACK
>>>>>>>
>>>>>>> No. This is machine specific. Same for all boards.
>>>>> NACK as you can have a flash at other place and more than one flash
>>>>> and the size depend on the flash
>>>>
>>>> Correct!! Size has to be board specific. Will modify it.
>>> and the start also as you may have 2 nor flash on different bank
>>>
>>
>> The start addresses in our case are fixed for a particular bank.
> but not for the nor so let this decide by every board
> not by the SoC
> 

The NOR memory is placed within the system memory address space.
For NAND offourse, it lies beyond system space. 

EMI is a Parallel NOR memory controller and the base address and 
maximum size of each bank is fixed in our system...

Regards
Vipin