[PATCH 1/6] ARM: mx5: use config to define boot related addresses

Richard Zhao linuxzsc at gmail.com
Thu Dec 9 02:28:42 EST 2010


2010/12/9 Uwe Kleine-König <u.kleine-koenig at pengutronix.de>:
> Hello,
>
> On Thu, Dec 09, 2010 at 10:08:31PM +0800, Richard Zhao wrote:
>> Signed-off-by: Richard Zhao <richard.zhao at freescale.com>
>> ---
>> This series of patch support mx50 reference design board. I've tested it using
>> initramfs on the board.
>>
>>  arch/arm/mach-mx5/Makefile.boot |    6 +++---
>>  1 files changed, 3 insertions(+), 3 deletions(-)
>>
>> diff --git a/arch/arm/mach-mx5/Makefile.boot b/arch/arm/mach-mx5/Makefile.boot
>> index 9939a19..388d2e8 100644
>> --- a/arch/arm/mach-mx5/Makefile.boot
>> +++ b/arch/arm/mach-mx5/Makefile.boot
>> @@ -1,3 +1,3 @@
>> -   zreladdr-y        := 0x90008000
>> -params_phys-y        := 0x90000100
>> -initrd_phys-y        := 0x90800000
>> +   zreladdr-$(CONFIG_SOC_IMX51)      := 0x90008000
>> +params_phys-$(CONFIG_SOC_IMX51)      := 0x90000100
>> +initrd_phys-$(CONFIG_SOC_IMX51)      := 0x90800000
> That is one of the places that is not multi-soc capable.  You can make
> it 66% less worse by just removing params_phys and initrd_phys.
Yes. Thanks!

Richard
>
> Best regards
> Uwe
>
> --
> Pengutronix e.K.                           | Uwe Kleine-König            |
> Industrial Linux Solutions                 | http://www.pengutronix.de/  |
>



More information about the linux-arm-kernel mailing list