[PATCH 1/6] ARM: mx5: use config to define boot related addresses

[Uwe Kleine-König]

Hello,

On Thu, Dec 09, 2010 at 10:08:31PM +0800, Richard Zhao wrote:
> Signed-off-by: Richard Zhao <richard.zhao at freescale.com>
> ---
> This series of patch support mx50 reference design board. I've tested it using
> initramfs on the board.
> 
>  arch/arm/mach-mx5/Makefile.boot |    6 +++---
>  1 files changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/arch/arm/mach-mx5/Makefile.boot b/arch/arm/mach-mx5/Makefile.boot
> index 9939a19..388d2e8 100644
> --- a/arch/arm/mach-mx5/Makefile.boot
> +++ b/arch/arm/mach-mx5/Makefile.boot
> @@ -1,3 +1,3 @@
> -   zreladdr-y	:= 0x90008000
> -params_phys-y	:= 0x90000100
> -initrd_phys-y	:= 0x90800000
> +   zreladdr-$(CONFIG_SOC_IMX51)	:= 0x90008000
> +params_phys-$(CONFIG_SOC_IMX51)	:= 0x90000100
> +initrd_phys-$(CONFIG_SOC_IMX51)	:= 0x90800000
That is one of the places that is not multi-soc capable.  You can make
it 66% less worse by just removing params_phys and initrd_phys.

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |