[LEDE-DEV] LEDE new image on gw5520

[Koen Vandeputte]

On 2017-11-09 16:40, Outback Dingo wrote:
> On Thu, Nov 9, 2017 at 4:16 PM, Koen Vandeputte
> <koen.vandeputte at ncentric.com> wrote:
>>
>> On 2017-11-09 15:55, Outback Dingo wrote:
>>> heres more data, we still have a no interfaces issue with recent LEDE
>>> trunk
>>>
>>>
>>>
>>> On Thu, Nov 2, 2017 at 6:42 PM, Outback Dingo <outbackdingo at gmail.com>
>>> wrote:
>>>> seems that ive lost my eth0 / eth1 interfeaces on a RECENT ... today
>>>> image built for the gw5520
>>>> i do however see the ifb0 and ifb1 interfaces... any ideas?
>>
>> Hi,
>>
>> As I have similar hardware, maybe I can help out. (GW 5510 and others)
>>
>> I'm not seeing the FEC driver being loaded in your log: (Freescale Ethernet)
>>
>>
>> Snip from my 5510:
>>
>>
>> [    0.692354] libphy: Fixed MDIO Bus: probed
>> [    0.693357] libphy: mdio_driver_register: mv88e6085
>> [    0.695036] 2188000.ethernet supply phy not found, using dummy regulator
>> [    0.697541] pps pps0: new PPS source ptp0
>> [    0.701333] libphy: fec_enet_mii_bus: probed
>>
>> --> [    0.702005] fec 2188000.ethernet eth0: registered PHC device 0
>>
>>
>>
>> Please run  "make kernel_menuconfig"  and check if CONFIG_FEC is selected.
>>
>>
>
>
> Hi, the following were selected under drivers / ethernet
>
>    [*]   Freescale devices
>                                   │ │
>   │ │                                <*>     FEC ethernet controller
> (of ColdFire and some i.MX CPUs)
> │ │
>   │ │                                < >     Freescale PQ MDIO
>                                                                     │ │
>   │ │                                < >     Freescale XGMAC MDIO
>                                                                     │ │
>   │ │                                < >     Gianfar Ethernet
>                                                                     │ │
>   │ │                                [*]   Hisilicon devices
>
>> Kind Regards,
>>
>> Koen

Hi,

Quickly checked a little more in-depth.

(My board is a GW52xx.)

Looking at dtsi, it seems that the fec part is not specified for the 552x

As a test, could you add attached patch to your build?
Just put it in  target/linux/imx6/patches-4.9 and do a full rebuild 
(make clean; make)


Thanks,

Koen
-------------- next part --------------
A non-text attachment was scrubbed...
Name: 999-fectest.patch
Type: text/x-patch
Size: 394 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/lede-dev/attachments/20171109/29c01cee/attachment-0001.bin>