[LEDE-DEV] LEDE new image on gw5520

Outback Dingo outbackdingo at gmail.com
Thu Nov 9 08:46:32 PST 2017


On Thu, Nov 9, 2017 at 5:38 PM, Koen Vandeputte
<koen.vandeputte at ncentric.com> wrote:
>
>
> On 2017-11-09 16:40, Outback Dingo wrote:
>>
>> On Thu, Nov 9, 2017 at 4:16 PM, Koen Vandeputte
>> <koen.vandeputte at ncentric.com> wrote:
>>>
>>>
>>> On 2017-11-09 15:55, Outback Dingo wrote:
>>>>
>>>> heres more data, we still have a no interfaces issue with recent LEDE
>>>> trunk
>>>>
>>>>
>>>>
>>>> On Thu, Nov 2, 2017 at 6:42 PM, Outback Dingo <outbackdingo at gmail.com>
>>>> wrote:
>>>>>
>>>>> seems that ive lost my eth0 / eth1 interfeaces on a RECENT ... today
>>>>> image built for the gw5520
>>>>> i do however see the ifb0 and ifb1 interfaces... any ideas?
>>>
>>>
>>> Hi,
>>>
>>> As I have similar hardware, maybe I can help out. (GW 5510 and others)
>>>
>>> I'm not seeing the FEC driver being loaded in your log: (Freescale
>>> Ethernet)
>>>
>>>
>>> Snip from my 5510:
>>>
>>>
>>> [    0.692354] libphy: Fixed MDIO Bus: probed
>>> [    0.693357] libphy: mdio_driver_register: mv88e6085
>>> [    0.695036] 2188000.ethernet supply phy not found, using dummy
>>> regulator
>>> [    0.697541] pps pps0: new PPS source ptp0
>>> [    0.701333] libphy: fec_enet_mii_bus: probed
>>>
>>> --> [    0.702005] fec 2188000.ethernet eth0: registered PHC device 0
>>>
>>>
>>>
>>> Please run  "make kernel_menuconfig"  and check if CONFIG_FEC is
>>> selected.
>>>
>>>
>>
>>
>> Hi, the following were selected under drivers / ethernet
>>
>>    [*]   Freescale devices
>>                                   │ │
>>   │ │                                <*>     FEC ethernet controller
>> (of ColdFire and some i.MX CPUs)
>> │ │
>>   │ │                                < >     Freescale PQ MDIO
>>                                                                     │ │
>>   │ │                                < >     Freescale XGMAC MDIO
>>                                                                     │ │
>>   │ │                                < >     Gianfar Ethernet
>>                                                                     │ │
>>   │ │                                [*]   Hisilicon devices
>>
>>> Kind Regards,
>>>
>>> Koen
>
>
> Hi,
>
> Quickly checked a little more in-depth.
>
> (My board is a GW52xx.)
>
> Looking at dtsi, it seems that the fec part is not specified for the 552x
>
> As a test, could you add attached patch to your build?
> Just put it in  target/linux/imx6/patches-4.9 and do a full rebuild (make
> clean; make)

This board was working fine with LEDE in September? so im curious how
a dtsi file would regress in a few weeks


>
>
> Thanks,
>
> Koen



More information about the Lede-dev mailing list