[LEDE-DEV] LEDE new image on gw5520

[Outback Dingo]

On Thu, Nov 9, 2017 at 4:16 PM, Koen Vandeputte
<koen.vandeputte at ncentric.com> wrote:
>
>
> On 2017-11-09 15:55, Outback Dingo wrote:
>>
>> heres more data, we still have a no interfaces issue with recent LEDE
>> trunk
>>
>>
>>
>> On Thu, Nov 2, 2017 at 6:42 PM, Outback Dingo <outbackdingo at gmail.com>
>> wrote:
>>>
>>> seems that ive lost my eth0 / eth1 interfeaces on a RECENT ... today
>>> image built for the gw5520
>>> i do however see the ifb0 and ifb1 interfaces... any ideas?
>
>
> Hi,
>
> As I have similar hardware, maybe I can help out. (GW 5510 and others)
>
> I'm not seeing the FEC driver being loaded in your log: (Freescale Ethernet)
>
>
> Snip from my 5510:
>
>
> [    0.692354] libphy: Fixed MDIO Bus: probed
> [    0.693357] libphy: mdio_driver_register: mv88e6085
> [    0.695036] 2188000.ethernet supply phy not found, using dummy regulator
> [    0.697541] pps pps0: new PPS source ptp0
> [    0.701333] libphy: fec_enet_mii_bus: probed
>
> --> [    0.702005] fec 2188000.ethernet eth0: registered PHC device 0
>
>
>
> Please run  "make kernel_menuconfig"  and check if CONFIG_FEC is selected.
>
>



Hi, the following were selected under drivers / ethernet

  [*]   Freescale devices
                                 │ │
 │ │                                <*>     FEC ethernet controller
(of ColdFire and some i.MX CPUs)
│ │
 │ │                                < >     Freescale PQ MDIO
                                                                   │ │
 │ │                                < >     Freescale XGMAC MDIO
                                                                   │ │
 │ │                                < >     Gianfar Ethernet
                                                                   │ │
 │ │                                [*]   Hisilicon devices

> Kind Regards,
>
> Koen