[LEDE-DEV] QCA Dakota support

K.Mani sailormani at gmail.com
Thu Mar 9 10:36:29 PST 2017


Initramfs image boots fine from the RAM.

Regards
Mani

On Thu, Mar 9, 2017 at 9:53 PM, Matthew McClintock
<msm-oss at mcclintock.net> wrote:
> On Thu, Mar 9, 2017 at 10:15 AM, K.Mani <sailormani at gmail.com> wrote:
>> Hi Matthew,
>>
>> (IPQ40xx) # smeminfo
>> flash_type:             0x6
>> flash_index:            0x0
>> flash_chip_select:      0x0
>> flash_block_size:       0x10000
>> flash_density:          0x1000000
>> partition table offset  0x0
>> No.: Name             Attributes            Start             Size
>>   0: 0:SBL1           0x0000ffff              0x0          0x40000
>>   1: 0:MIBIB          0x001040ff          0x40000          0x20000
>>   2: 0:QSEE           0x0000ffff          0x60000          0x60000
>>   3: 0:CDT            0x0000ffff          0xc0000          0x10000
>>   4: 0:DDRPARAMS      0x0000ffff          0xd0000          0x10000
>>   5: 0:APPSBLENV      0x0000ffff          0xe0000          0x10000
>>   6: 0:APPSBL         0x0000ffff          0xf0000          0x80000
>>   7: 0:ART            0x0000ffff         0x170000          0x10000
>>   8: 0:HLOS           0x0000ffff         0x180000         0x400000
>>   9: rootfs           0x0000ffff         0x580000         0xa80000
>>
>> Is this a nand or nor booting board?
>> Don't know.
>>
>> SF: MX25L25635E, it's spi-nor i guess.
>
> Sounds right.
>
>>
>> If i have to flash 'initramfs', should it be on HLOS partition start address?
>>
>> Also attached a old boot log.
>
> No you can just load to memory and boot from there, no need to mess
> with flash at this point.
>
> -M



More information about the Lede-dev mailing list