[LEDE-DEV] QCA Dakota support

[Matthew McClintock]

On Thu, Mar 9, 2017 at 10:15 AM, K.Mani <sailormani at gmail.com> wrote:
> Hi Matthew,
>
> (IPQ40xx) # smeminfo
> flash_type:             0x6
> flash_index:            0x0
> flash_chip_select:      0x0
> flash_block_size:       0x10000
> flash_density:          0x1000000
> partition table offset  0x0
> No.: Name             Attributes            Start             Size
>   0: 0:SBL1           0x0000ffff              0x0          0x40000
>   1: 0:MIBIB          0x001040ff          0x40000          0x20000
>   2: 0:QSEE           0x0000ffff          0x60000          0x60000
>   3: 0:CDT            0x0000ffff          0xc0000          0x10000
>   4: 0:DDRPARAMS      0x0000ffff          0xd0000          0x10000
>   5: 0:APPSBLENV      0x0000ffff          0xe0000          0x10000
>   6: 0:APPSBL         0x0000ffff          0xf0000          0x80000
>   7: 0:ART            0x0000ffff         0x170000          0x10000
>   8: 0:HLOS           0x0000ffff         0x180000         0x400000
>   9: rootfs           0x0000ffff         0x580000         0xa80000
>
> Is this a nand or nor booting board?
> Don't know.
>
> SF: MX25L25635E, it's spi-nor i guess.

Sounds right.

>
> If i have to flash 'initramfs', should it be on HLOS partition start address?
>
> Also attached a old boot log.

No you can just load to memory and boot from there, no need to mess
with flash at this point.

-M