[LEDE-DEV] RT5350 spi half duplex?

Giuseppe Lippolis giu.lippolis at gmail.com
Wed Jan 18 12:10:54 PST 2017


Hi,
I’m experimenting the spi interface on a RT5350 target.
Its spi driver set the interface as half duplex

        master->dev.of_node = pdev->dev.of_node;
        master->mode_bits = RT2880_SPI_MODE_BITS;
        master->bits_per_word_mask = SPI_BPW_MASK(8);
        master->min_speed_hz = clk_get_rate(clk) / 128;
        master->max_speed_hz = clk_get_rate(clk) / 2;
        master->flags = SPI_MASTER_HALF_DUPLEX;
        master->setup = rt2880_spi_setup;
        master->prepare_message = rt2880_spi_prepare_message;
        master->set_cs = rt2880_spi_set_cs;
        master->transfer_one = rt2880_spi_transfer_one,

but from the datasheet it seems that the device is full duplex capable.
There are some reason to set the driver in this way?

Thanks, bye. 





More information about the Lede-dev mailing list