[LEDE-DEV] Ubnt power beam board - back to defaults after reboot

[Gareth Parker]

Hi Jiri
This is a common problem on XM devices due to new uboot on AirOS >= 5.6.x,
although I haven't got any XW devices to test but its possibly the same?
Try downgrading back to AirOS v5.5.11 or less or apply the following patches
which I can confirm fix the problem on my XM devices.

https://raw.githubusercontent.com/freifunk-gluon/gluon/1f400189cfbae697b5018
0bccf876784a3c03423/patches/openwrt/0026-kernel-backport-spi-nor-driver-from
-4.4.9.patch
https://raw.githubusercontent.com/freifunk-gluon/gluon/1f400189cfbae697b5018
0bccf876784a3c03423/patches/openwrt/0027-kernel-mtd-spi-nor-wait-until-statu
s-register-writes-are-ready.patch
https://raw.githubusercontent.com/freifunk-gluon/gluon/1f400189cfbae697b5018
0bccf876784a3c03423/patches/openwrt/0028-kernel-mtd-spi-nor-unlock-Winbond-f
lashs.patch

Cheers,

Gareth

-----Original Message-----
From: Lede-dev [mailto:lede-dev-bounces at lists.infradead.org] On Behalf Of
Jiri Pirko
Sent: Thursday, 20 October 2016 8:29 p.m.
To: openwrt-devel at lists.openwrt.org; lede-dev at lists.infradead.org
Subject: [LEDE-DEV] Ubnt power beam board - back to defaults after reboot

Hi.

Trying Ubiquity power beam M5. According to the instructions on openwrt
wiki, I'm using loco m5 firmware. All looks fine, only configuration is lost
after every reboot.

Tried:
openwrt-15.05.1-ar71xx-generic-ubnt-loco-m-xw-squashfs-sysupgrade.bin
openwrt-15.05-ar71xx-generic-ubnt-loco-m-xw-squashfs-sysupgrade.bin
openwrt-ar71xx-generic-ubnt-loco-m-xw-squashfs-sysupgrade.bin
lede-ar71xx-generic-ubnt-loco-m-xw-squashfs-sysupgrade.bin

All with the same result.

I remember I had some similar problem in past on a different board, and I
believe that there was and issue on definition of nand size. Not really
sure.

Any ideas?

Jiri

_______________________________________________
Lede-dev mailing list
Lede-dev at lists.infradead.org
http://lists.infradead.org/mailman/listinfo/lede-dev