[LEDE-DEV] Ubnt power beam board - back to defaults after reboot

[Jiri Pirko]

Hi.

Trying Ubiquity power beam M5. According to the instructions on openwrt
wiki, I'm using loco m5 firmware. All looks fine, only configuration is
lost after every reboot.

Tried:
openwrt-15.05.1-ar71xx-generic-ubnt-loco-m-xw-squashfs-sysupgrade.bin
openwrt-15.05-ar71xx-generic-ubnt-loco-m-xw-squashfs-sysupgrade.bin
openwrt-ar71xx-generic-ubnt-loco-m-xw-squashfs-sysupgrade.bin
lede-ar71xx-generic-ubnt-loco-m-xw-squashfs-sysupgrade.bin

All with the same result.

I remember I had some similar problem in past on a different board, and
I believe that there was and issue on definition of nand size. Not
really sure.

Any ideas?

Jiri