[LEDE-DEV] Linksys ea8500 switch configuration

[Adrian Panella]

> El 18/06/2016, a las 12:51 p.m., Josh Bendavid <joshbendavid at gmail.com> escribió:
> 
> Ok.  If the configuration I am suspecting for the stock firmware is
> correct, then port 6 is unused and it shouldn't matter how it's
> configured.
> 
> Actually it's possible that some of this is anyways dynamically
> configurable through the switch registers.  (ie even if the stock
> firmware has the eth1 connected directly to the WAN phy as I suspect,
> it might still be possible/preferable to configure the switch so that
> it is more like AP148 with gmacX (eth1) -> rgmii -> switch port 6

Is there any way I can dump all registers from the switch? I could flash back stock FW and see how it is set up.


> 
> Actually I don't think gmac2 even supports rgmii, so if both ethernet
> interfaces are connected to the switch chip/PHY's with rgmii then they
> would have to be gmac0 and gmac1...