[LEDE-DEV] Help on porting new device (DCS-933L)

[John Crispin]

On 13/12/2016 09:43, John Crispin wrote:
> 
> 
> On 13/12/2016 09:17, Luiz Angelo Daros de Luca wrote:
>> Hello,
>>
>> I'm trying to port LEDE to a new device DCS-933L. It's a dlink ip
>> camera with 8MB Flash and 64 MB RAM. Currently my branch is published
>> on https://github.com/luizluca/source/tree/add_dcs933lb1
>>
>> It seems to be going well (as it is my first port) but I cannot see
>> the webcam. I guess its camera and audio device are connected via USB.
>>
>> This is the factory bootlog:
>> https://wiki.openwrt.org/toh/d-link/dcs-930l#factory_bootlog_dcs-933l
>> and this is my current bootlog: http://pastebin.com/pJjPB90E
>>
>> I'm not an DTS expert and all I did was trial'n'error. Maybe it is
>> just a simple mistake.
>> Maybe it is related to this message "ralink-usb-phy usbphy: invalid resource".
> 
> 
> that error is unrelated. newer phys need a more complete init. the error
> is a side effect of that init not being required.
> 
> if you look at lines 117/118 you will see that the phy loads just fine
> and that a few lines further down the ports are being detected.
> 
> my guess would be that the power to the webcam is controlled via a gpio.
> 
> 	John
> 

do you have the A1 or A2 version ? i want to download the GPL source
from d-link and see if i can find any info regarding a gpio inside it.
but there are 2 versions of the HW

	John