hostap_cs.conf

Andrea G. Forte andreaf
Wed Feb 18 12:11:22 PST 2004


We modified the original wlan-ng file to load the hostap modules instead
of the prism2 modules for our card. We tried to use the hostap config file
as Pavel said, but when inserting the card it would not be recognized as
"inserted" and therefore no drivers would be loaded.
With the modified wlan-ng config file hostap gets loaded but in the dmesg
message we get the error:
wlan0: prism2_open
wlan0 unsupported ioctl(0x89f1)
We are using the Linksys WCF11 card, wireless extensions 12 with Kernel
ARM-linux 2.4.6

Thank you for your help,
Andrea

On Tue, 17 Feb 2004, Pavel Roskin wrote:

> On Tue, 17 Feb 2004, Sangho Shin wrote:
>
> > When we install hostap, hostap_cs.conf is copied and it is referenced
> > when we put the card.
> > But, in Zaurus, wlan-ng.conf is referenced as default. How can we change
> > to make Zaurus reference hostap_cs.conf instead of wlan-ng.conf?
>
> Remove wlan-ng.conf or rename hostap_cs.conf to something that begins with
> "x", "y" or "z" and still ends with ".conf".  cardmgr reads configuration
> files in alphabetic order and later entries have priority.
>
> When I need to choose between drivers, I create file
> /etc/pcmcia/zlocal.conf and put the entries for the cards I have into that
> file.
>
> --
> Regards,
> Pavel Roskin
> _______________________________________________
> HostAP mailing list
> HostAP at shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap
>




More information about the Hostap mailing list