[PATCH 4/4] mci: dwcmshc-sdhci: add support for Kalray Coolidge v2 SoC eMMC controller

[Yann Sionneau]

Kalray Coolidge v2 SoC eMMC controller needs static tx delay tuning even
for basic standard or high speed modes.

This patch also adds possibility to do some vendor specific tuning
in set_ios().
This will be needed for Coolidge v2 for >50 MHz speeds and HS200/HS400
modes.

Signed-off-by: Yann Sionneau <ysionneau at kalrayinc.com>
---
 drivers/mci/dwcmshc-sdhci.c | 40 +++++++++++++++++++++++++++++++++++++
 1 file changed, 40 insertions(+)

diff --git a/drivers/mci/dwcmshc-sdhci.c b/drivers/mci/dwcmshc-sdhci.c
index d9c51752db..5017a1f56e 100644
--- a/drivers/mci/dwcmshc-sdhci.c
+++ b/drivers/mci/dwcmshc-sdhci.c
@@ -9,11 +9,16 @@
 #include <dma.h>
 #include <malloc.h>
 #include <mci.h>
+#include <of_device.h>
 #include <linux/err.h>
 #include <linux/clk.h>
 
 #include "sdhci.h"
 
+#define tx_delay_static_cfg(delay)      (delay << 5)
+#define tx_tuning_clk_sel(delay)        (delay)
+
+#define DWCMSHC_GPIO_OUT  0x34 /* offset from vendor specific area */
 #define CARD_STATUS_MASK (0x1e00)
 #define CARD_STATUS_TRAN (4 << 9)
 
@@ -22,6 +27,13 @@ static int do_send_cmd(struct mci_host *mci, struct mci_cmd *cmd, struct mci_dat
 struct dwcmshc_host {
 	struct mci_host mci;
 	struct sdhci sdhci;
+	int vendor_specific_area;
+	const struct dwcmshc_callbacks *cb;
+};
+
+struct dwcmshc_callbacks {
+	void (*init)(struct mci_host *mci, struct device *dev);
+	void (*set_ios)(struct mci_host *mci, struct mci_ios *ios);
 };
 
 static inline struct dwcmshc_host *priv_from_mci_host(struct mci_host *h)
@@ -222,6 +234,9 @@ static void dwcmshc_mci_set_ios(struct mci_host *mci, struct mci_ios *ios)
 		return;
 	}
 
+	if (host->cb && host->cb->set_ios)
+		host->cb->set_ios(mci, ios);
+
 	/* enable bus clock */
 	sdhci_write16(&host->sdhci, SDHCI_CLOCK_CONTROL, val | SDHCI_CLOCK_CARD_EN);
 }
@@ -253,6 +268,9 @@ static int dwcmshc_mci_init(struct mci_host *mci, struct device *dev)
 	dev_dbg(host->mci.hw_dev, "host version4: %s\n",
 		ctrl2 & SDHCI_CTRL_V4_MODE ? "enabled" : "disabled");
 
+	if (host->cb && host->cb->init)
+		host->cb->init(mci, dev);
+
 	return 0;
 }
 
@@ -284,6 +302,8 @@ static void dwcmshc_set_dma_mask(struct device *dev)
 
 static int dwcmshc_probe(struct device *dev)
 {
+	const struct dwcmshc_callbacks *dwcmshc_cb =
+			of_device_get_match_data(dev);
 	struct dwcmshc_host *host;
 	struct resource *iores;
 	struct mci_host *mci;
@@ -309,6 +329,7 @@ static int dwcmshc_probe(struct device *dev)
 	host->sdhci.base = IOMEM(iores->start);
 	host->sdhci.mci = mci;
 	host->sdhci.max_clk = clk_get_rate(clk);
+	host->cb = dwcmshc_cb;
 
 	mci->hw_dev = dev;
 	mci->init = dwcmshc_mci_init;
@@ -337,6 +358,10 @@ static int dwcmshc_probe(struct device *dev)
 	dev_dbg(host->mci.hw_dev, "host controller version: %u\n",
 		host->sdhci.version);
 
+	host->vendor_specific_area = sdhci_read32(&host->sdhci,
+						   SDHCI_P_VENDOR_SPEC_AREA);
+	host->vendor_specific_area &= SDHCI_P_VENDOR_SPEC_AREA_MASK;
+
 	ret = mci_register(&host->mci);
 	if (ret)
 		goto err_register;
@@ -354,8 +379,23 @@ static int dwcmshc_probe(struct device *dev)
 	return ret;
 }
 
+static void dwcmshc_coolidgev2_init(struct mci_host *mci, struct device *dev)
+{
+	struct dwcmshc_host *host = priv_from_mci_host(mci);
+
+	// configure TX delay to set correct setup/hold for Coolidge V2
+	sdhci_write32(&host->sdhci,
+		      host->vendor_specific_area + DWCMSHC_GPIO_OUT,
+		      tx_delay_static_cfg(0xf) | tx_tuning_clk_sel(4));
+}
+
+struct dwcmshc_callbacks kalray_coolidgev2_callbacks = {
+	.init = dwcmshc_coolidgev2_init,
+};
+
 static struct of_device_id dwcmshc_dt_ids[] = {
 	{ .compatible = "snps,dwcmshc-sdhci", },
+	{ .compatible = "kalray,coolidge-v2-dwcmshc-sdhci", .data = &kalray_coolidgev2_callbacks },
 	{ }
 };
 
-- 
2.43.0