short entropy delay causes RNG hardware error

[Stefano Manni]

Hello Ahmad,

On Mon, 2024-08-05 at 18:56 +0200, Ahmad Fatoum wrote:
> 
> Do you have rngd enabled? You don't need this anymore with a recent
> enough Linux (>= v6.1 or perhaps earlier).
> 
> This doesn't fix the underlying issue of course, but it will save you
> some CPU time.

Your speculation that rngd is running comes from the error pops every
10seconds? I cannot see any systemd service related to rng running on
my machine. How can I disable it?

> 
> > And if I try to read from device the
> > same error occurs:
> > 
> >   ~# dd if=/dev/hwrng of=/dev/null bs=1 count=1
> >   caam_jr 2141000.jr: 2000005b: CCB: desc idx 0: RNG: Hardware
> > error
> >   dd: /dev/hwrng: Invalid argument
> > 
> > No errors are fired in barebox where the RNG self-test is run
> > succesfully:
> > 
> >   rng_self_test: RNG software self-test passed
> >   caam 2140000.crypto at 2140000.of: Instantiated RNG4 SH0
> >   caam 2140000.crypto at 2140000.of: Instantiated RNG4 SH1
> >   caam 2140000.crypto at 2140000.of: registering rng-caam
> > 
> > Here [1] I found that enlarging the entroy delay may help so I
> > tried to
> > do the same in barebox by changing RTSDCTL_ENT_DLY_MIN from 3200 to
> > 4800 and it succeded, I no longer see those errors in linux and
> > trying
> > to read from the device works perfectly.
> 
> That's the correct resolution, yes.
> 
> > The strange thing is that on another board based on imx6sx I never
> > see
> > those errors.
> 
> There can be quite some variance in the time needed to collect enough
> entropy, even for SoCs cut from the same wafer, so this is not
> unusual.
> 
> > Is it something new to you? 
> 
> This issue has been there for a long time. Optimally, NXP would
> store a suitable delay value into the OTP in the factory or at least
> public suitable initial delay values for their SoCs, but
> unfortunately
> they don't.
> 
> > May we change the delay? On linux-imx 6.6.3 3200 is still used.
> 
> The driver starts at 3200 and increases the delay in steps of 40
> until
> it reaches a suitable value. There's a maximum (12800), but it's not
> used as that would slow down the RNG. Thus the search at probe time
> for
> the lowest possible delay value that still allows instantiating the
> RNG.
> 
> Unfortunately, a successful instantiated RNG doesn't necessarily mean
> that
> actual runtime usage of the CAAM won't trigger errors.
> 
> Increasing RTSDCTL_ENT_DLY_MIN to a value appropriate for your board
> is
> thus the way to go. I think it would be appropriate to add a device
> tree
> property, so the minimum delay value can be set on a per-board basis.
> 

Got it.

Thank you