[PATCH v5 0/22] at91: move reset vector to board code

Sascha Hauer s.hauer at pengutronix.de
Tue Jan 9 02:35:35 PST 2018


On Sat, Jan 06, 2018 at 10:04:50PM +0100, Sam Ravnborg wrote:
> Hi all.
> 
> The following patchset moves the reset vector
> for at91 boards from mach-at91 to board code.
> This is similar to what other boards do and is done to
> prepare for multi-image and DT support.
> 
> The patchset includes removal of the mmccpu board.
> 
> The patchset convert all at91 boards and thus clean up
> the old code that resided in mach-at91/
> 
> The second patch have minimal impact, but prepares for a
> board-by-board conversion.
> All temporary CONFIG symbols are gone at the end of this series.
> 
> I kept Jean-Christophe PLAGNIOL-VILLARD and others
> copyright in all the created files and did not add
> copyright myself. The patchset does IMO not add any
> copyrightable material from my side as this is
> in reality just moving around code.
> 
> With this patchset applied we no longer have any
> places where we call board code from mach-at91/
> thus allowing us to introduce multi-images.
> And we are also on the right track to introduce
> DT support for additional AT91 based boards.
> 
> The patchset was successfully booted on a AT91SAM9263EK,
> and all defconfigs was built (expect the ones that failed
> to build before this patchset was applied).
> 
> I consider the patchset ready for barebox-next.

Applied, thanks.

Sascha

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |



More information about the barebox mailing list