[PATCH 6/6] ARM: pfla02: Set new ethernet phy tx timings

[Alexander Aring]

On Mon, Mar 17, 2014 at 07:24:35AM +0100, Sascha Hauer wrote:
> On Fri, Mar 14, 2014 at 05:01:33PM +0100, Alexander Aring wrote:
> > On Fri, Mar 14, 2014 at 02:30:20PM +0100, Sascha Hauer wrote:
> > > From: Christian Hemp <c.hemp at phytec.de>
> > > 
> > > TX_CLK line is approx. 54mm longer than other TX lines which adds
> > > a delay of 0.36ns. RGMII need a delay of min. 1.0ns. This mean we have to add
> > > a delay of 0.64ns. We choose 0.78 to have a little gap. This can be done by
> > > setting GTX pad skew value to 11100
> > >  => Set register 2.8 (RGMII Clock Pad Skew) to 0x038F.
> > > 
> > > Signed-off-by: Christian Hemp <c.hemp at phytec.de>
> > > ---
> > >  arch/arm/boards/phytec-phyflex-imx6/board.c | 20 ++++++++++++++++++++
> > >  1 file changed, 20 insertions(+)
> > > 
> > > diff --git a/arch/arm/boards/phytec-phyflex-imx6/board.c b/arch/arm/boards/phytec-phyflex-imx6/board.c
> > > index f510407..3db88da 100644
> > > --- a/arch/arm/boards/phytec-phyflex-imx6/board.c
> > > +++ b/arch/arm/boards/phytec-phyflex-imx6/board.c
> > > @@ -21,6 +21,9 @@
> > >  #include <gpio.h>
> > >  #include <init.h>
> > >  #include <of.h>
> > > +#include <fec.h>
> > > +
> > > +#include <linux/micrel_phy.h>
> > >  
> > >  #include <mach/imx6.h>
> > >  
> > > @@ -36,6 +39,21 @@ static int eth_phy_reset(void)
> > >  	return 0;
> > >  }
> > >  
> > > +static void mmd_write_reg(struct phy_device *dev, int device, int reg, int val)
> > > +{
> > > +	phy_write(dev, 0x0d, device);
> > > +	phy_write(dev, 0x0e, reg);
> > > +	phy_write(dev, 0x0d, (1 << 14) | device);
> > > +	phy_write(dev, 0x0e, val);
> > > +}
> > > +
> > > +static int ksz9031rn_phy_fixup(struct phy_device *dev)
> > > +{
> > > +	mmd_write_reg(dev, 2, 8, 0x039F);
> > > +
> > commit msg says 0x038F and here is 0x039F. Which one is correct now?
> 
> 0x39f is correct, I squashed a followup commit into this one without
> fixing the commit message. I changed the commit message accordingly.
> 

ok, thanks Sascha. I just saw this and want to be sure that this is the
right value.

- Alex