i.MX6 frame buffer inside barebox?

[Sascha Hauer]

On Wed, Jun 18, 2014 at 04:26:48PM +0200, Holger Schurig wrote:
> Hi, I'm a bit puzzled. I compiled my barebox with
> 
> CONFIG_CMD_SPLASH=y
> CONFIG_VIDEO=y
> CONFIG_DRIVER_VIDEO_IMX_IPUV3=y
> CONFIG_DRIVER_VIDEO_IMX_IPUV3_LVDS=y
> CONFIG_DRIVER_VIDEO_SIMPLEFB=y
> 
> and some entries in the device tree about it (see below). And when I
> boot barebox, I see /dev/fb0.
> 
> However, the LVDS signals don't come out of the CPU, e.g. LVDS_CLK0_P
> / LVDS_CLK0_N is silent. Do I need something to enable the drive as
> well?  Simply writing to /dev/fb0, e.g. with the "splash" or "mw -d
> /dev/fdb0" command, doesn't seem to do the magic.

have you enabled the framebuffer? fb0.enable=1

Sascha

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |