[PATCH 2/4] AT91: move have_intensity_bit into board setup

[Jean-Christophe PLAGNIOL-VILLARD]

On 22:22 Mon 02 Sep     , Darren Garnier wrote:
> Signed-off-by: Darren Garnier <dgarnier at reinrag.net>
\why this is soc specific

Best Regards,
J.
> ---
> arch/arm/boards/at91sam9261ek/init.c     | 2 ++
> arch/arm/mach-at91/at91sam9261_devices.c | 2 --
> 2 files changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm/boards/at91sam9261ek/init.c b/arch/arm/boards/at91sam9261ek/init.c
> index 00fc745..b420a48 100644
> --- a/arch/arm/boards/at91sam9261ek/init.c
> +++ b/arch/arm/boards/at91sam9261ek/init.c
> @@ -223,6 +223,8 @@ static void ek_add_device_lcdc(void)
> 
> 	if (machine_is_at91sam9g10ek())
> 		ek_lcdc_data.lcd_wiring_mode = ATMEL_LCDC_WIRING_RGB;
> +	else
> +		ek_lcdc_data.has_intensity_bit = true;
> 
> 	at91_add_device_lcdc(&ek_lcdc_data);
> }
> diff --git a/arch/arm/mach-at91/at91sam9261_devices.c b/arch/arm/mach-at91/at91sam9261_devices.c
> index b522afb..ba52e56 100644
> --- a/arch/arm/mach-at91/at91sam9261_devices.c
> +++ b/arch/arm/mach-at91/at91sam9261_devices.c
> @@ -218,8 +218,6 @@ void __init at91_add_device_lcdc(struct atmel_lcdfb_platform_data *data)
> {
> 	BUG_ON(!data);
> 
> -	data->have_intensity_bit = true;
> -
> #if defined(CONFIG_FB_ATMEL_STN)
> 	at91_set_A_periph(AT91_PIN_PB0, 0);	/* LCDVSYNC */
> 	at91_set_A_periph(AT91_PIN_PB1, 0);	/* LCDHSYNC */
> -- 
> 1.8.3.1
> 
> 
> 
> _______________________________________________
> barebox mailing list
> barebox at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/barebox