barebox on i.MX53 in serial downloader boot mode

[Wjatscheslaw Stoljarski (Slawa)]

On 11/04/2013 04:07 PM, Eric Bénard wrote:
> Hi Wjatscheslaw,
>
> Le Mon, 04 Nov 2013 16:00:49 +0100,
> "Wjatscheslaw Stoljarski (Slawa)"
> <wjatscheslaw.stoljarski at kiwigrid.com> a écrit :
>
>> On 11/04/2013 01:48 PM, Eric Bénard wrote:
>>> Hi,
>>>> has anyone tried to start barebox on i.MX53 in 11 boot mode (serial
>>>> downloader)? I've tried on Freescale Loco board with pmic da9053, but
>>>> without success. In 00 boot mode (internal boot) works perfectly. U-Boot
>>>> works in both modes. DCD in u-boot and in barebox is the same. Even I
>>>> can turn on LEDs with DCD in 11 boot mode on Loco.
>>>>
>>> works fine here, what are you using to download barebox ?
>> I'm using imx-usb-loader. But I've tried MfgTool from Freescale too with
>> the same result.
>>
> ok sorry it's working here (on a custom board) in 11 boot mode but using
> serial port to load it. IIRC USB was only tested in 00 as a fallback
> when NAND flash is blank.
>
> Eric
Sorry, I forget to mention that I'm using serial downloader via USB.

Hm... I've just tried to boot u-boot image in 11 mode, and from u-boot 
start barebox. And it's works. Why then can I not boot barebox directly?

Wjatscheslaw