barebox on i.MX53 in serial downloader boot mode

[Eric Bénard]

Hi Wjatscheslaw,

Le Mon, 04 Nov 2013 16:00:49 +0100,
"Wjatscheslaw Stoljarski (Slawa)"
<wjatscheslaw.stoljarski at kiwigrid.com> a écrit :

> On 11/04/2013 01:48 PM, Eric Bénard wrote:
> > Hi,
> >> has anyone tried to start barebox on i.MX53 in 11 boot mode (serial
> >> downloader)? I've tried on Freescale Loco board with pmic da9053, but
> >> without success. In 00 boot mode (internal boot) works perfectly. U-Boot
> >> works in both modes. DCD in u-boot and in barebox is the same. Even I
> >> can turn on LEDs with DCD in 11 boot mode on Loco.
> >>
> > works fine here, what are you using to download barebox ?
> I'm using imx-usb-loader. But I've tried MfgTool from Freescale too with 
> the same result.
> 
ok sorry it's working here (on a custom board) in 11 boot mode but using
serial port to load it. IIRC USB was only tested in 00 as a fallback
when NAND flash is blank.

Eric