Booting linux on a custom iMX27 board

Igor igt1972 at
Fri Jan 27 06:23:03 EST 2012

Hi Uwe,

first of all thanks for the answer.
A few minutes ago I could see the answer that Sasha Hauer sent to Marek Belisko
(that was having a problem similar to mine) and it was "illuminating"!

> Do you have configured the right output port for low level debug? Did
> you pass the earlyprintk kernel parameter?

I didn't know that early printk has to be enabled with a cmd line option!
So I changed Barebox bootargs and I could see my 3.0.8 kernel talking to me!
And this helped the following debug...

>> What's the reason for the boot failure?
> Probably not a bootloader problem.

You were "probably" right... ;-)


"Don't find fault, find a remedy."
(Henry Ford)

More information about the barebox mailing list