about the dm9000 in mini2440
jbe at pengutronix.de
Fri Dec 7 03:45:17 EST 2012
Yi Qingliang wrote:
> On Thursday, December 06, 2012 12:27:45 PM Eric Bénard wrote:
> > Le Thu, 06 Dec 2012 15:55:23 +0000,
> > Yi Qingliang <niqingliang2003 at gmail.com> a écrit :
> > > the address of dm9000 is 0x28000000, it should be cs5, but in function
> > > "mini2440_devices_init", it set the cs4 instead, why??
> > The mini2440 supported in Barebox is this one and maybe not the one
> > your are using ;-)
> > http://www.friendlyarm.net/products/mini2440
> there is "mini2440 friendlyARM" on my board, whose color is white.
> blue pcb, maybe friendlyARM has multi version mini2440?
FriendlyARM has some copyist. A blue PCB I have never seen yet.
> I say the 0x28000000 is cs5, based on the memory layout picture in the
> manual. although the schematics is same as Juergen Beisert's.
And the schematics says it is CS4.
> I can't get the original disk, only the board. So how to check the EED0?
> ps: In the manual of dm9000, it said that EED0 is pulled down internaly.
Sure. But if you have some power floating around your board the chip might
detect a high level at system start. But this idea is just a shot into the
Pengutronix e.K. | Juergen Beisert |
Linux Solutions for Science and Industry | http://www.pengutronix.de/ |
More information about the barebox