storing barebox to flash /dev/nand0

[Belisko Marek]

On Fri, Sep 10, 2010 at 1:01 PM, Jean-Christophe PLAGNIOL-VILLARD
<plagnioj at jcrosoft.com> wrote:
>> >
>> > Okay, 256 kiB
>> >
>> >> crw-------          0 nand0.barebox.bb
>> >
>> > Again, 0?
>> >
>> > For the environment it looks different:
>> >
>> >> crw-------     131072 env_raw
>> >> crw-------     131072 env0
>> >> crw-------     131072 nand0.bareboxenv
>> >> crw-------     131072 nand0.bareboxenv.bb
>> >
>> > All are 128 kiB.
>> OK maybee there is mix from mtd_parts in env config with vital partitions.
>> I keep just vital partitions in code but result is the same:
>> cr-------- 4294967295 zero
>> crw-------       2973 defaultenv
>> crw------- 4294967295 mem
>> crw-------  268435456 nand0
>> cr--------    8388608 nand_oob0
>> crw-------          0 ram0
>> crw-------         32 phy0
>> crw-------     262144 self_raw
>> crw-------          0 self0
>> crw-------     131072 env_raw
>> crw-------     131072 env0
>>
>> self0 should be bb for self_raw where to store barebox. But why it has size 0?
>> Don't understand? Am I doing something wrong? For env it works fine.
> If I understand correctly your log you have a bad block on it
You're right. I erase NAND again and then bad block for 0x00000000 is gone. I
can load barebox to flash. Sorry for spamming.
>
> Best Regards,
> J.
>



-- 
as simple and primitive as possible
-------------------------------------------------
Marek Belisko - OPEN-NANDRA
Freelance Developer

Ruska Nova Ves 219 | Presov, 08005 Slovak Republic
Tel: +421 915 052 184
skype: marekwhite
icq: 290551086
web: http://open-nandra.com