Driver support for QCA6174 chip using SDIO interface

[Valo, Kalle]

Hi,

sorry for the late reply, I was on vacation and catching up now.

Erik Stromdahl <erik.stromdahl at gmail.com> writes:

> Firmware and board files are normally distributed by the module vendor
> (MuRata, Silex, etc.).
>
> Firmware is depending on chipset, so this is something QCA should be able
> to provide.
>
> Board files are module dependent and contains calibration etc. and should
> definitely be obtained from the module vendor.
>
> If you have a discrete design you would most likely have to create your own
> board file (using ART etc.)
>
> Kalle:
> Perhaps you (or someone else at QCA) can initiate the work to make the sdio
> firmware publicly available?

I'll send a request forward internally, but that might take a while as
I'm heavily backlogged at the moment.

-- 
Kalle Valo