QCA998X not working at all

[Ben Greear]

On 11/19/2015 07:35 AM, Sebastian Gottschall wrote:
> Am 19.11.2015 um 16:33 schrieb Ben Greear:
>> On 11/19/2015 07:10 AM, Sebastian Gottschall wrote:
>>>   6.064984] ath10k_pci 0000:01:00.0: enabling device (0140 -> 0142)
>>> [    6.065432] ath10k_pci 0000:01:00.0: pci irq legacy interrupts 0 irq_mode 0 reset_mode 0
>>> [    8.448583] ath10k_pci 0000:01:00.0: unable to read from the device
>>> [    8.448614] ath10k_pci 0000:01:00.0: could not execute otp for board id check: -110
>>> [    8.453657] ath10k_pci 0000:01:00.0: failed to get board id from otp for qca99x0: -110
>>> [    8.461352] ath10k_pci 0000:01:00.0: could not probe fw (-110)
>>>
>>>
>>> it seems that the there is some sort of problem with the otp. unfortunatly ath10k gives also no usefull information about the reason.
>>> this is a embedded ap148 based device (ipq8064) with QCA998X chipsets on it
>>
>> What kernel, what firmware, what board.bin are you using?
> plain ath10k with kernel 3.18.23. standard firmware-5 from ath10k github, same for board.

The kernel tree below at least booted up the 4x4 NIC for me with stock upstream firmware.

http://dmz2.candelatech.com/git/gitweb.cgi?p=linux.ath/.git;a=summary

git clone git://dmz2.candelatech.com/linux.ath

It has most of my patch-set applied...but not sure any of those patches
are really needed for basic functionality.

Thanks,
Ben


-- 
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc  http://www.candelatech.com