[PATCH v4 2/2] ramips: add support for Wavlink WS-WN572HP3 4G

Jan-Niklas Burfeind git at aiyionpri.me
Thu Dec 1 01:15:14 PST 2022


On 12/1/22 09:25, Arınç ÜNAL wrote:
> On 30.11.2022 23:35, Jan-Niklas Burfeind wrote:
>> Wavlink WS-WN572HP3 4G is an 802.11ac
>> dual-band outdoor router with LTE support.
>>
>> Specifications;
>> * Soc: MT7621DAT
>> * RAM: 128MiB
>> * Flash: NOR 16MiB GD-25Q128ESIG3
>> * Wi-Fi:
>>    * MT7613BEN: 5GHz
>>    * MT7603EN: 2.4GHz
>> * Ethernet: 2x 1GbE
>> * USB: None - only used internally
>> * LTE Modem: Quectel EC200T-EU
>> * UART: 115200 baud
>> * LEDs:
>>    * 7 blue at the front
>>      * 1 Power
>>      * 2 LAN / WAN
>>      * 1 Status
>>      * 3 RSSI (annotated 4G)
>>    * 1 green at the bottom (4G LED)
>> * Buttons: 1 reset button
>>
>> Installation:
>> * press and hold the reset button while powering on the device
>> * keep it pressed for ten seconds
>> * connect to 192.168.10.1 via webbrowser (chromium/chrome works, at
>>    least Firefox 106.0.3 does not)
>> * upload the sysupgrade image, confirm the checksum, wait 2 minutes
>>    until the device reboots
>>
>> Revert to stock firmware:
>> * same as installation but use the recovery image for WL-WN572HP3
>>
>> Signed-off-by: Jan-Niklas Burfeind <git at aiyionpri.me>
> 
> Acked-by: Arınç ÜNAL <arinc.unal at arinc9.com>
> 
> Keep this if you send a new version.
> 
> Arınç

I will, thank you; was not sure about whether I should, as I introduced 
new changes everytime I updated it.

Jan-Niklas



More information about the openwrt-devel mailing list